This chapter describes the various tasks that are provided when using the Watertight Geometry meshing guided workflow:
- 3.1. Watertight Geometry Workflow Limitations
- 3.2. Importing Geometries
- 3.3. Importing Body of Influence Geometries
- 3.4. Adding Local Sizing
- 3.5. Generating the Surface Mesh
- 3.6. Setting Up Periodic Boundaries
- 3.7. Describing the Geometry
- 3.8. Applying Share Topology
- 3.9. Enclosing Fluid Regions
- 3.10. Creating Regions
- 3.11. Updating Regions
- 3.12. Adding Thin Volume Meshing Controls
- 3.13. Adding Boundary Layers
- 3.14. Adding Multizone Controls
- 3.15. Generating the Multizone Mesh
- 3.16. Generating the Volume Mesh
- 3.17. Updating Boundaries
- 3.18. Improving the Surface Mesh
- 3.19. Adding Boundary Types
- 3.20. Improving the Volume Mesh
- 3.21. Transforming the Volume Mesh
- 3.22. Extruding the Volume Mesh
- 3.23. Adding Linear Mesh Patterns
- 3.24. Managing Zones
- 3.25. Modifying Mesh Refinement
- 3.26. Creating Local Refinement Regions
- 3.27. Running Custom Journal Commands