This chapter describes the various tasks that are provided when using the Watertight Geometry meshing guided workflow:

• 3.1. Watertight Geometry Workflow Limitations
• 3.2. Importing Geometries
• 3.3. Importing Body of Influence Geometries
• 3.4. Adding Local Sizing
• 3.5. Generating the Surface Mesh
• 3.6. Setting Up Periodic Boundaries
• 3.7. Describing the Geometry
• 3.8. Applying Share Topology
• 3.9. Enclosing Fluid Regions
• 3.10. Creating Regions
• 3.11. Updating Regions
• 3.12. Adding Thin Volume Meshing Controls
• 3.13. Adding Boundary Layers
• 3.14. Adding Multizone Controls
• 3.15. Generating the Multizone Mesh
• 3.16. Generating the Volume Mesh
• 3.17. Updating Boundaries
• 3.18. Improving the Surface Mesh
• 3.19. Adding Boundary Types
• 3.20. Improving the Volume Mesh
• 3.21. Transforming the Volume Mesh
• 3.22. Extruding the Volume Mesh
• 3.23. Adding Linear Mesh Patterns
• 3.24. Managing Zones
• 3.25. Modifying Mesh Refinement
• 3.26. Creating Local Refinement Regions
• 3.27. Running Custom Journal Commands