This chapter discusses the general multiphase models that are available in Ansys Fluent. For information about the various theories behind the general multiphase models in Ansys Fluent, see Multiphase Flows in the Theory Guide.
Information about using the general multiphase models in Ansys Fluent is presented in the following sections:
- 26.1. Introduction
- 26.2. Steps for Using a Multiphase Model
- 26.3. Setting Up the VOF Model
- 26.4. Setting Up the Mixture Model
- 26.5. Setting Up the Eulerian Model
- 26.6. Population Balance Model
- 26.7. Setting Up the Wet Steam Model
- 26.8. Solution Strategies for Multiphase Modeling
- 26.9. Multiphase Case Check
- 26.10. Postprocessing for Multiphase Modeling