SE
SE,
File, --, --,
TOLER, nStartVN
Defines a superelement.
FileThe name (case sensitive) of the file containing the original superelement matrix created by the generation pass (
Sename.sub). The default is the current Jobname.--,--Unused fields.
TOLERTolerance used to determine if use pass nodes are noncoincident with master nodes having the same node numbers. Defaults to 0.0001. Use pass nodes will always be replaced by master nodes of the same node number. However, if a use pass node is more than
TOLERaway from the corresponding master node, a warning is generated.nStartVNNode number to be assigned to the first virtual node created to store the generalized coordinates in a component mode synthesis analysis. See "Notes" for more information.
Notes
Defines a superelement by reading in the superelement matrices and master nodes from the superelement matrix file. The matrix file (File.sub) must be available from the substructure generation pass. The proper element type (MATRIX50) must be active (TYPE) for this command. A scratch file called File.sord showing the superelement names and their corresponding element numbers is also written.
nStartVN should be chosen so as to offset
the virtual node numbers from the other node numbers used in the model. Otherwise,
nStartVN is internally set by the program to fulfill that
condition. The node number defined through nStartVN is considered
only if applied on the first issued SE command.
nStartVN can also be defined during the generation pass using the
CMSOPT command. If nStartVN is defined on both
CMSOPT and SE commands, the larger number
prevails.