Body To DT can be created by converting 3D CAD to Drivetrain's Deep groove ball bearing, Angular contact ball bearing, Tapered roller bearing, and Cylindrical roller bearing.
Figure 14.18: Rule to define the name of 3D CAD to be defined with a Bearing
| Syntax | |||||||||||||||||||
|
"Bearing Type"__"Bearing Name"__"Bearing Part Name"__"Assembly Body Name" "Bearing Type"__"Bearing Name"__"Bearing Part Name"__"Assembly Body Name"__"Length" | |||||||||||||||||||
| Parameters | |||||||||||||||||||
| Bearing Type |
The command to define the type of Bearing as follows.
| ||||||||||||||||||
| Bearing Name | The name of the Bearing is defined by this parameter. | ||||||||||||||||||
| Bearing Part Name |
The command to define the name of bearing part as follows.
| ||||||||||||||||||
|
Assembly Body Name | The name of the body to which the bearing is to be assembled | ||||||||||||||||||
| Length | When naming double row bearings, you to define the length. Length is the axial length of the bearing. | ||||||||||||||||||
| Example | |||||||||||||||||||
|
- Example of defining a Deep Groove Ball Bearing to satisfy the following conditions. 1) Bearing Name : Brg_Input_L 2) Inner raceway of bearing must be assembled on the shaft called Shaft_Input 3) Outer raceway of bearing must be assembled on the housing called Housing DGBB__Brg_Input_L__INN__Shaft_Input DGBB__Brg_Input_L__OUT__Housing - Example of defining a EasyFlex ShaftSet named ShaftSet_Output EFSFT__ShaftSet_Output | |||||||||||||||||||