Click the config icon 
to assign the input parameters. The input parameter window is split
into two sections:
A graphical window on the left.
The solvers runs on the right.
The graphical window, common to all solvers, will be described in The FENSAP-ICE Solver Manager. The format and content of the input parameter files vary from solver to solver.
The next chapters of this manual contain detailed information on how to configure these parameters.
Note: The input parameters can only be defined once the grid file is assigned, since features such as boundary conditions are grid-dependent. The config icon turns blue when all necessary files have been properly assigned.
To import an input parameter file, right-click the config icon and select .
Tip: You can drag & drop the Input Parameter icons from FENSAP into DROP3D, and from FENSAP or DROP3D into ICE3D. Parameters common to the various runs are then set to the same values.
To copy paste the config file:
Select the config icon of the source run
Copy (Ctrl+C)
Select the config icon of the target run
Paste (Ctrl+V)
Important: You are strongly encouraged to review the input parameters before launching the calculation.