Below is a review of the commands regarding the *MAT252 keyword. First, the commands are covered which are the same for both workflows. Then, in Output: Initial Stress Cards and Output: New *PART and *MAT252 Cards, the additional commands are discussed which are specific to the workflows of Output: Initial Stress Cards and Output: New *PART and *MAT252 Cards, respectively.

TargetMaterialModel = INT	This must be set to 252.
MAT252Parameter = DOUBLE, DOUBLE, DOUBLE, DOUBLE, DOUBLE, DOUBLE	This command is used to inform the Envyo application about the six parameters that are necessary for computing the four functions given in Output: Initial Stress Cards section. The six parameters must be given in the following order: , , , , , and .
MAT252Strategy = INT	1 - Output: Initial Stress Cards is triggered. 2 - Output: New *PART and *MAT252 Cards is triggered.
MAT252Definition = FILE	This command expects a .k- or .key-file containing a single instance of a *MAT252 keyword. The parsed keyword tells the Envyo application what material parameters to work with in this workflow.
DegreeOfCureHistoryPosition = INT	This command is used for telling the Envyo application at which history position is the DoC stored in the source mesh.