The previous section describes workflows that apply to the case, where instead of mapping the results from a source to a target mesh, only the data on a source mesh is modified. No actual mapping takes place. If the discussed workflows are used while transferring data from one mesh to another, the notions from Output: Initial Stress Cards and Output: New *PART and *MAT252 Cards are modified as follows: In both cases, after performing step 1, the DoC-data stored on the integration points is mapped from the source mesh to the target mesh. After that, the procedure continues from step 2 for the target mesh, and the Envyo application's input file must contain the appropriate commands regarding the mapping.