10.1.2. EasyFlex Creation

Figure 10.4: EasyFlex entities from the ribbon menu

Figure 10.5: Steps to create an EasyFlex entity

Step	Operation
1st step	Select EasyFlex on the ribbon menu as shown in Figure 10.4: EasyFlex entities from the ribbon menu.
2nd step	Select one of the EasyFlex entities as shown in Figure 10.4: EasyFlex entities from the ribbon menu.
3rd step	Follow the prescribed creation steps for each EasyFlex entity as shown in Figure 10.5: Steps to create an EasyFlex entity.

As shown in the table above, you can create an EasyFlex entity through several steps. The creation steps for each EasyFlex entity are shown the table below. For additional information about each step, refer to the creation page for each EasyFlex Entity.

Figure 10.6: Creation methods for EasyFlex Entities

Type	Creation method
Boundary Condition	Faces > Reference Frame > Properties
	Faceset (Color Face) > Reference Frame > Properties
	Body > Color > Reference Frame > Properties
RBE Single	Faces > Point > Properties
	Faceset (Color Face) > Point > Properties
	Body > Color > Point > Properties
RBE Pair	Faces > Faces > Point > Properties
	Faceset (Color Face) > Faceset (Color Face) > Point > Properties
	Body > Color > Body > Color > Point > Properties
PLOAD	Faces > Properties
	Faceset (Color Face) > Properties
	Body > Color > Properties
CLOAD Face	Faces > Properties
	Faceset (Color Face) > Properties
	Body > Color > Properties
CLOAD Range	Body > Point > Direction > Properties
Tie	Faces > Faces > Properties
	Faceset (Color Face) > Faceset (Color Face) > Properties
	Body > Color > Body > Color > Properties
Weld	Body > Body > Point > Point > Direction > Properties
	Body > Body > Multi-Points > Direction > Properties
	File > Body > Body > Properties