SPVAL
SPVAL, TBLNO, CURVNO, SV1, SV2, SV3, SV4, SV5, SV6, SV7
Defines multi-point response spectrum values.
TBLNOInput table number. It corresponds to
TBLNOon the SPFREQ command.CURVNOInput curve number. It corresponds to
CURVNOon the SPDAMP command (optional).SV1,SV2,SV3, , , . . . ,SV7Spectral values corresponding to the frequency points (SPFREQ) and damping ratio (SPDAMP). Values are interpreted as defined with the SPUNIT command.
Notes
Defines multi-point response spectrum values to be associated
with the previously defined frequency points (SPFREQ). It can also be associated with the previously defined damping
value (SPDAMP). If CURVNO is not specified, the input spectrum is not associated with a damping
value.
Repeat SPVAL command for additional values, up to the number of frequency points (SPFREQ). Values are added after the last nonzero value.
The interpolation method between response spectrum points and
curves is specified using KeyInterp on
the SPUNIT command. It is logarithmic by default.
Use the SPTOPT and STAT commands to list current spectrum curve values.
This command is also valid in PREP7.