NWPLAN
NWPLAN, WN, NORIG, NXAX, NPLAN
Defines the working plane using three nodes.
WNWindow number whose viewing direction will be modified to be normal to the working plane (defaults to 1). If
WNis a negative value, the viewing direction will not be modified. If fewer than three points are used, the viewing direction of windowWNwill be used instead to define the normal to the working plane.NORIGNode number defining the origin of the working plane coordinate system. If
NORIG= P, graphical picking is enabled and all remaining command fields are ignored (valid only in the GUI).NXAXNode number defining the x-axis orientation (defaults to the x-axis being parallel to the global X-axis; or if the normal to the working plane is parallel to the global X-axis, then defaults to being parallel to the global Y-axis).
NPLANNode number defining the working plane (the normal defaults to the present display view (/VIEW) of window
WN).
Notes
Defines a working plane to assist in picking operations using three nodes as an alternate to the WPLANE command. The three nodes also define the working plane coordinate system. A minimum of one node (at the working plane origin) is required. Immediate mode may also be active. See the WPSTYL command to set the style of the working plane display.
This command is valid in any processor.