CYL5
CYL5, XEDGE1
, YEDGE1
, XEDGE2
, YEDGE2
, DEPTH
Creates a circular area or cylindrical volume by end points.
XEDGE1
,YEDGE1
Working plane X and Y coordinates of one end of the circle or cylinder face.
XEDGE2
,YEDGE2
Working plane X and Y coordinates of the other end of the circle or cylinder face.
DEPTH
The perpendicular distance (either positive or negative based on the working plane Z direction) from the working plane representing the depth of the cylinder. If
DEPTH
= 0 (default), a circular area is created on the working plane.
Notes
Defines a circular area anywhere on the working plane or a cylindrical volume with one face anywhere on the working plane by specifying diameter end points. For a solid cylinder of 360°, the top and bottom faces will be circular (each area defined with four lines) and they will be connected with two surface areas (each spanning 180°). See the CYL4, PCIRC, and CYLIND commands for alternate ways to create circles and cylinders.