Computing a Custom Profile

Opening a signal in Pa is required.

When necessary, adding cursors to mark out a signal is required.

1. From the drop-down list, select Custom profile.

   

   The Custom profile is selected and the default related indicators are displayed.

2. Click Edit.

   

   The Custom profile window is displayed.

3. Click a tab then click Unselect all to remove all indicators of the current tab from Custom profile.

4. Repeat the step 2 and 3 to fully clean up the Custom profile.

5. In each tab, select indicators to be included in the Custom profile.

6. Click OK.

7. In Signals, tick the boxes corresponding to the signal(s) for which you want to compute the indicators.
8. If some of the selected signals are marked out with cursors, in Signals, click the signal, then tick:
   
   

   • the Start-End check box to calculate the indicators over the whole signal,

   • the check box corresponding to a chunk between two consecutive cursors to calculate the indicators over this specific part of the signal,

   • the Start-End check box and one or several check boxes corresponding to chunks to calculate the indicators over each selected signal and chunks.

   The signal(s) as well as chunks are selected.

9. Repeat the step 3 for each signal including cursors.

10. Click Compute.

The results of the Custom profile are displayed in a table.

You can now save the results and, if any, display the curves.