Specifying RMxprt Winding Data
To define the winding data for an RMxprt machine:
- In the Project Manager tree, under Machine, open the folder that requires a winding, and double-click Winding to open the winding Properties window.
- For some machine types this would be Machine > Rotor > Winding, for others, Machine > Stator > Winding.
- You can also enter values in the Properties section of the desktop without opening a separate window.
- Specify the desired settings.
- Click OK to close the Properties window.
The specific properties available depend on the specific machine.
The following machine types have winding data available:
- Three-Phase Induction Motors (stator winding) and (rotor winding)
- Three-Phase Synchronous Machines (stator winding) and (rotor winding)
- Brushless PMDC Motors (stator winding)
- Adjust-Speed Synchronous Machines (stator winding)
- PMDC Motors (rotor winding)
- Switched Reluctance Motors (stator winding)
- Line-Start Permanent-Magnet Synchronous Motors (stator winding)
- Universal Motors (stator winding) and (rotor winding)
- General DC Machines (rotor winding)
- Claw-Pole Alternators (stator winding)
- Generic Rotating Machines