On the Project Schematic, right-click the Parameter Set bar and select Properties.

Corresponding settings are shown below in the Properties pane.

Use the steps outlined in Updating Design Points in Remote Solve Manager to set the following properties:

1. Solution Process

2. Design Point Update Process

   ---

   Note:  Because design point updates are performed only on output parameters, a System Coupling system that does not affect outputs may not be updated during a design point update. However, when updating retained design points (including Current), you can ensure that all project systems are updated. To do so, set the Retained Design Point property to Update full project, then right-click the Current design point and select Update selected design points.

   ---

Save the project.

If you are working in an archived project, save the project to a permanent location.

Update the design point(s), using any of the methods documented in Updating Design Points (that is, updating the Current design point, selected design points, or all design points).