/ZOOM
/ZOOM, WN, Lab, X1, Y1, X2, Y2
Zooms a region of a display window.
WNWindow number to which command applies (defaults to 1).
LabLabel to define the desired type of zoom:
OFF
—
Turns zoom off (refits image of entire model to the window).
BACK
—
Goes back to previous zoom setting (five successive back ups, maximum).
SCRN
—
Interprets X1,Y1 as the screen coordinates of the center of a square zoom region; X2,Y2 as the screen coordinates of a point on one side of that square.
RECT
—
Interprets X1,Y1 and X2,Y2 as the screen coordinates of two opposite corners of a rectangular zoom region.
Notes
Zooms (centers and magnifies) the specified region of a display window. /ZOOM will operate on a display that has been formed by an explicit graphics action command (APLOT, EPLOT, etc.). /ZOOM has no effect on an "immediate" graphics display. When /ZOOM is executed, the display is automatically replotted such that the specified zoom region is centered and sized to fill the window.
Auto resizing is disabled when you issue the /ZOOM command. To restore auto resizing, issue the /AUTO command, or select from the Pan, Zoom, Rotate box.
This command is valid in any processor.