VLIST
VLIST, NV1
, NV2
, NINC
Lists the defined volumes.
NV1
,NV2
,NINC
List volumes from
NV1
toNV2
(defaults toNV1
) in steps ofNINC
(defaults to 1). IfNV1
= ALL (default),NV2
andNINC
are ignored and all selected volumes (VSEL) are listed. IfNV1
= P, graphical picking is enabled and all remaining command fields are ignored (valid only in the GUI). A component name may also be substituted forNV1
(NV2
andNINC
are ignored).
Notes
An attribute (TYPE, MAT, REAL, or ESYS) listed as a zero is unassigned; one listed as a positive value indicates that the attribute was assigned with the VATT command (and will not be reset to zero if the mesh is cleared); one listed as a negative value indicates that the attribute was assigned using the attribute pointer [TYPE, MAT, REAL, or ESYS] that was active during meshing (and will be reset to zero if the mesh is cleared). A "-1" in the "nodes" column indicates that the volume has been meshed but there are no interior nodes. The volume size is listed only if a VSUM command has been performed on the volume. Volume orientation attributes (KZ1 and KZ2) are listed only if a VEORIENT command was previously used to define an orientation for the volume.
This command is valid in any processor.