PRRSOL
PRRSOL, Lab
Prints the constrained node reaction solution.
LabNodal reaction load type. If blank, use the first ten of all available labels. Valid labels are:
Structural force labels: FX, FY or FZ (forces); F (FX, FY and FZ); MX, MY or MZ (moments); M (MX, MY and MZ); BMOM (bimoments). Thermal force labels: HEAT, HBOT, HE2, HE3, . . ., HTOP (heat flow). Fluid force labels: FLOW (fluid flow); VFX, VFY and VFZ (fluid forces); VF (VFX, VFY and VFZ). Electric force labels: AMPS (current flow); CHRG (charge); CURT (current); VLTG (voltage drop). Magnetic force labels: FLUX (magnetic flux); CSGZ (magnetic current segment); CURT (current), VLTG (voltage drop). Diffusion labels: RATE (diffusion flow rate).
Notes
Prints the constrained node reaction solution for the selected nodes in the sorted sequence. For coupled nodes and nodes in constraint equations, the sum of all reactions in the coupled or constraint equation set appears at the primary node of the set. Results are in the global Cartesian coordinate directions unless transformed (RSYS).
PRRSOL is not valid if any load is applied to a constrained node in the direction of the constraint and any of the following is true:
PRRSOL provides the total reaction solution (static, plus damping, plus inertial, as appropriate based on the analysis type); however, modal reactions include only the static contribution.
Use PRRFOR instead of PRRSOL with the FORCE command to obtain only the static, damping, or inertial components.
When using distributed-memory parallel processing, in a spectrum
analysis or a PSD analysis performed with Elcalc = YES on the
SPOPT command, use PRRFOR instead of
PRRSOL to print the maximum reaction forces (spectrum analysis) or reaction
forces variances of 1-σ solutions, as PRRSOL may lead to more
conservative results.