/LARC
/LARC, XCENTR
, YCENTR
, XLRAD
, ANGLE1
, ANGLE2
Creates annotation arcs (GUI).
XCENTR
Arc X center location (-1.0 < X < 1.0).
YCENTR
Arc Y center location (-1.0 < Y < 1.0).
XLRAD
Arc radius length.
ANGLE1
Starting angle of arc.
ANGLE2
Ending angle of arc. The arc is drawn counterclockwise from the starting angle,
ANGLE1
, to the ending angle,ANGLE2
.
Notes
This command defines annotation arcs to be written directly onto the display at a specified location.
The command is generated by the Graphical User Interface (GUI) and will appear in the log file (Jobname.log) if annotation is used. It is not intended to be typed in directly in a Mechanical APDL session (although it can be included in an input file for batch input or for use with the /INPUT command).
All arcs are shown on subsequent displays unless the annotation is turned off or deleted. Issueu /LSPEC to set the attributes of the arc.
This command is valid in any processor.