AMPOWDER

AMPOWDER, TPOWDER, HPOWDER, MATFACTOR
Specifies the thermal conditions of the powder in an additive manufacturing analysis.

Valid Products: Pro | Premium | Enterprise | PrepPost | Solver | AS add-on

TPOWDER

Temperature of the newly added powder.

HPOWDER

Effective convection coefficient from the part to the powder bed.

MATFACTOR

Knockdown factor applied to the solid material properties (to obtain the powder material properties). Default = 0.01.

Command Default

No heat flow is included into the powder bed.

Notes

This command applies only to the powder-bed fusion (AMTYPE,PBF) process.

To estimate the convection coefficient (HPOWDER), divide the conduction property of the powder (its KXX) by a characteristic conduction length into the powder (for example, ¼ of the distance from the part boundary to the build-chamber wall).

The program uses the knockdown factor (MATFACTOR) to estimate the powder properties. The program applies the factor (typically 0.01) to the solid material properties to estimate the properties of the material in its powder state. The powder-state properties are used during the heating of the new layer (before its subsequent solidification and cooldown) prior to the next layer being applied.

This command is also valid in PREP7.

For more information, including a list of the elements and commands used in an additive manufacturing analysis, see Additive Simulation in Mechanical in the LPBF Simulation Guide.

Menu Paths

This command cannot be accessed from a menu.