Expand/Collapse all
Introduction to the Tutorials
1. Structural Analysis of a Short Fiber Reinforced Part Tutorial
1.1. Problem Description
1.2. Use Material Designer to Compute the Properties of a Short Fiber Reinforced Plastic
1.3. Import and Map the Fiber Orientation Tensor in Mechanical
1.4. Results and Discussion
2. Calibration and Validation of the Elasto-Plastic Properties of a Short Fiber Composite Tutorial
2.1. Problem Description
2.2. Import the Injection Molding Simulation Results
2.3. Import and Map the Fiber Orientation Tensor in Mechanical
2.4. Use Material Designer to Compute the Elastic Properties of a Short Fiber Reinforced Plastic
2.5. Combine the Material Response with the Mapped Injection Simulation Data
2.6. Reverse Engineering the Constituents Properties
2.7. Calibration of the Plasticity Model Against Experimental Data
2.8. Import and Use the Validated Material in a New Model
3. Structural and Modal Analysis of a Short Fiber Reinforced Car Mirror Tutorial
3.1. Use Material Designer to Compute the Properties of a Fiber Reinforced Plastic
3.2. Import the Injection Molding Simulation Results
3.3. Add an Overmolded Laminate to the Analysis
4. Accounting for Weld lines in the Simulation of Injection Molded Parts
4.1. Problem Description
4.2. Mapping and Visualization of the Weld Lines
4.3. Assigning a Different Material to the Weld Lines
4.4. Considerations for Mechanical Modeling of Weld Lines
4.5. References
5. Drop Test Scenario for a Mobile Phone
5.1. Problem Description
5.2. Calibration of the Material Card using Material Designer
5.3. Model Preparation in Mechanical
5.4. Solution and Additional Notes