Starting to Listen to a Signal Marked Out with Cursors

This procedure shows how to listen to part of a signal that is highlighted with cursors.

To Start Listening to a Signal Marked Out with Cursors:

Prerequisites: You need to mark out a signal with cursors.
  1. Go to the Playback Bar at the bottom of the Ansys Sound: Analysis and Specification window.
  2. Click Start to select the cursor from which to start playback.
  3. Click End to select the cursor from which to end playback.
  4. Click the Play button to start to listen to the marked out signal.
    Tip: To quickly listen to a signal selection, you may use the Expand selection tool :

    1. Click Cursor management then click a point in the signal to specify the start of the selection.

    2. Click Expand selection to select and highlight in black the signal selection to listen to.

    3. Click Play .

The listening starts.