Contents Optimization » Optimization with Ansys WorkbenchPrint page Optimization with Ansys Workbench The following section presents you how to run an optimization with Ansys Workbench. This section contains the following topics:Speos in Ansys WorkbenchThis page quickly introduces Ansys Workbench, the tool used by Speos to perform result and system optimization.Creating a Speos system in Ansys WorkbenchThis page shows the main steps to create a Speos system in Ansys Workbench. The Speos system in Ansys Workbench allows you to create a link between the two software. This link/bridge allows the software to exchange input and output data.Linking Static Structural Solution to Speos GeometryYou can create a connection between the Solution cell of a Static Structural system and the Geometry cell of a Speos system. When the link is created, *.scdoc and *.obj files or *.pmdb and *.obj files containing geometry, mesh, and deformed mesh information are transferred. From this information, warping is applied to the geometry.Optimization ToolsThe following section introduces how you can optimize Speos results with Ansys Workbench. « OptimizationSpeos in Ansys Workbench »