This section describes the available options for mapping of material properties for *MAT_4A_MICROMEC (*MAT 215). The initial input is the same as above, with minor changes on the target options and additional cards that are specifically for initializing material properties for (*MAT 215) with the *INITIAL_STRESS_SOLID card.
This section covers:
| TargetMaterialModel = 215 | Define the ID of the target material model corresponding to [20]. It must be 215. |
| MapStress = YES | Define if *INITIAL_STRESS_SOLID cards are written. If the data is available for the *MAT 215 material model via *INITIAL_STRESS_SOLID cards, this option must be set to YES. |
| MapMainDir = NO |
Activates the mapping of the main directions onto *ELEMENT SOLID ORTHO cards. For the usage with *MAT 215, this option is set to NO. |
| ETYP = INT | 1 - Reduced integrated solid elements. 2 - Fully integrated solid elements. |
|
MapWeldline = YES NO |
Define if weldlines are considered within the mapping. You must provide the respective Moldex3D *.nwd file. If MapWeldline= YES, define the following two cards: WeldlinePID and WeldlineRADIUS. |
| WeldlinePID = INT | Define the part ID that is assigned to weldline elements. |
| WeldlineRADIUS = DOUBLE | Define the radius for the weldline elements. This is a scale factor based on the average element size of the component, which enables adjusting the number of elements that are considered within the weldline zone. |