Verify the boundary conditions.
On the Physics tab under Zones, click Boundaries.
The Boundary Conditions Task Page opens, with nine boundary conditions in the zones list.
Review inlet parameters.
Double-click the inlet zone.
The Pressure Inlet dialog opens.
On the Momentum tab, verify that Gauge Total Pressure is set to the following expression:
10 [kPa] * sin(2.*PI*t/0.02[s]) This value limits the input pressure and indicates that the pressure is a function of time.
Tip: To view the sinusoidal wave of the valve pressure, open the Expression Editor ( ), enter
0.01
(the simulation end time) for the Max setting, and click Refresh ( ).Click Close to exit the dialog.
Review outlet parameters.
Double-click the outlet zone.
The Pressure Outlet dialog opens.
On the Momentum tab, verify that Gauge Pressure is set to the default of 0 [Pa].
Click Close to exit the dialog.