Verify Setup Cell States

On Workbench's Project Schematic, verify the state of each Setup cell, as follows:

  • The Setup cell for both the Transient Structural and the Fluid-Flow (CFX) systems should be in an Up-to-Date ( ) state.

  • The Setup cell for the System Coupling system should be in an Attention Required ( ) state. (If it is in a Refresh Required state, right-click the cell and select Refresh.)

Figure 49: Project Schematic ready for a partial setup export

Project Schematic ready for a partial setup export

Note:  This tutorial focuses on exporting a partial setup. To export a full setup, you would finish the co-simulation setup in Workbench, not performing the export until the System Coupling system is also in an Up-to-Date ( ) state.