Verify the excitations to be generated by the AC power supply.
In the Project Manager, expand BusBarTransient / Maxwell3DDesign (Transient) / Excitations.
There are three bus bar objects: bus1, bus2, and bus3.
Expand each of the bus bar objects.
Note that a single-conductor input coil terminal and a single-conductor output coil terminal is defined for each.
Review the excitation for each of the bus bar objects, performing the following steps on each one:
Double-click the bus bar object.
The Winding dialog opens.
Under Parameters, verify the following settings:
Type is set to Current.
Solid is selected.
Current is set to the following expressions:
bus1 is set to
7070A*sin(2*pi*60*time)
bus2 is set to
7070A*sin(2*pi*60*time-120deg)
bus3 is set to
7070A*sin(2*pi*60*time-240deg)
Each bus bar carries 7070A current at 60 Hz frequency, but each at a different phase.
Click Cancel to close the dialog.