Creating a Hole Using a Drill Chart
- Select Drill chart as the Series.
- Enter a Diameter.
- Enter a letter, decimal value, fraction (1/64, 3/32, etc.), or number (#1, #2, etc.)
- Units are assumed but can be overridden. For example, if Units are metric, 5.94 is assumed to be 5.94mm. Override the default
by entering 0.234".
- Diameter as entered is matched to the corresponding hole in the appropriate
chart. Hover over the Preview to see the callout information.
- Place the hole on a face.
- Click Complete, or double-click.