Control Options

Select Left, Right, Top, Bottom, or Not Shown.

Default is OFF. When selected, this option displays a view orientation gizmo, as shown below, in the design window. You can click a linear gizmo arrow to rotate the design to a new orientation in 3D, or a rotational arrow to rotate the design in 90-degree increments in the plane of the screen.

Select this option to display a small toolbar near your cursor when you right-click. The contents of the mini-toolbar depend on the tool you are using. You can click or scroll the middle mouse button to hide the mini-toolbar, and it fades as you move the mouse away from it. The mini-toolbar is shown in the image below.

Allows you to use the radial menu to change select modes while other tools are active, and gives you quick access to the Pull, Move, Fill, and Combine tools. If you select this option, you can select one or both of the following methods to open the radial menu:

• Show after holding left mouse button for N ms
• Show after clicking right mouse button, while holding left mouse button down

Select this option to display arrows next to your cursor that indicate the directions in which you can move your mouse to edit the selected object. The arrows also convey the change in size that will occur if you pull in that direction.

Adjust the slider to control the transparency of the cursor arrows. Move the slider to the right to make the arrows more opaque or move it to the right to make them more transparent. The arrows are set to opaque in the image below.

Move the slider to increase or decrease the size of the Move handle relative to the size of the Design window, as shown in the image below.

Change the position and size of the toolbar displayed for the sketch grid. You can set the Position (Bottom, or Corner), and the Size (Large, or Small). The defaults are Bottom and Large.