*DATABASE_EXTENT_BINARY
Control to some extent the content of binary output databases d3plot, d3thdt, and d3part. Four parameters are set by LS-DYNA:
Card1
STRFLG: Flag for including the strain tensor for shells.
SIGFLG: Flag for including the stress tensor for shells.
EPSFLG: Flag for including the effective plastic strains for shells.
Card3
MSSCL: Output nodal information related to mass scaling into the d3plot database.
THERM = 2 when Solver Type under Analysis Settings is set to Coupled Structural Thermal Analysis; 0 otherwise.
*DATABASE_BINARY_D3PLOT
Specifies the sampling parameters for the binary D3PLOT results plotting file.
Card
DT = End Time divided by Value from the Time History Output Controls section of the Analysis Settings if Calculate Results At is set to Equally Spaced Time Points ( this value defaults to 20).
*DATABASE_BINARY_INTFOR
Specifies the sampling parameters for the binary intfor results file. This file contains contact information (pressure, nodal contact forces).
Card
DT = End Time divided by Value from the Time History Output Controls section of the Analysis Settings if Calculate Results At is set to Equally Spaced Time Points (this value defaults to 20).