The Extract Curves from Surfaces option allows you to extract the boundary curves from a surface. Specify whether the selected surface is Bspline or Faceted.
For Bspline surfaces the following options are available.
- Check Topology
If enabled, curves will be created only on surfaces edges that do not have curves attached to them.
- Create New
If enabled, a new curve will be created for each surface edge.
For Faceted surfaces the following options are available.
- Angle for surfaces
Curves will be extracted only from surfaces with angles greater than the specified angle.
- Min number of segments
Only curves with the specified minimum number of segments will be extracted.
- Which curve segments
Specify whether curves will be extracted from the interior, exterior, or both sides of the surface.