The Mesh from Edges option allows you to close holes by selecting
the edges that surround it.
- Mesh type
specifies the appropriate surface mesh elements available.
- Edges
allows you to select the edges that surround the holes.
- Surface Projection
allows you to project new nodes onto the nearest surface.
- Single loop & complete edges
if enabled, it will try to complete a loop from the edges selected. If disabled, it will not mesh if the selected edges do not form a complete loop.
- Interpolation surface
interpolates the meshing area by a biquadratic approximation in order to generate a smooth surface.
- Keep volume consistent
if enabled, makes sure that the surface mesh and volume mesh are consistent with each other after remeshing.
Note: This only applies to tetra meshes.