TBPLOT
TBPLOT, Lab
, MAT
, TBOPT
, TEMP
, SEGN
Displays the material data table.
Lab
Data table label. Valid labels are: MELAS, BKIN, BISO, BH, GASKET, and JOIN. Defaults to the active table label. For B-H data, also valid are: NB to display NU-B2, MH to display MU vs. H, and SBH, SNB, SMH to display the slopes of the corresponding data.
MAT
Material number to be displayed (defaults to the active material).
TBOPT
Gasket material or joint element material option to be plotted.
The following gasket material options are valid only when
Lab
= GASKET:ALL
—
Plots all gasket data.
COMP
—
Plots gasket compression data only.
LUNL
—
Plots gasket linear unloading data with compression curve.
NUNL
—
Plots gasket nonlinear unloading data only.
The following joint element material options are valid only when Lab = JOIN:
JNSA
—
Plots nonlinear stiffness data that is applicable to all relevant directions.
JNSn
—
Plots only the specified nonlinear stiffness data. The "n" can be 1, 4, or 6. For example, JNS4 plots only the nonlinear stiffness data specified in the local direction 4 (ROTX).
JNDA
—
Plots nonlinear damping data that is applicable to all relevant directions.
JNDn
—
Plots only the specified nonlinear damping data. The "n" can be 1, 4, or 6. For example, JND4 plots only the nonlinear damping data specified in the local direction 4 (ROTX).
JNFA
—
Plots nonlinear hysteretic friction data that is applicable to all relevant directions.
JNFn
—
Plots only the specified nonlinear hysteretic friction data. The "n" can be 1, 4, or 6. For example, JNF4 plots only the nonlinear hysteretic friction data specified in local direction 4 (ROTX).
TEMP
Specific temperature at which gasket data or joint element material data will be plotted (used only when
Lab
= GASKET or JOIN). UseTEMP
= ALL to plot gasket data or joint element material data at all temperatures.SEGN
Segment number of plotted curve (valid only when
Lab
= GASKET):NO
—
Segment number is not added to plotted curve (default).
YES
—
Segment number is added to plotted curve. This option is ignored if the number of data points in a curve exceeds 20.