/FOCUS
/FOCUS, WN, XF, YF, ZF, KTRANS
Specifies the focus point (center of the window).
WNWindow number (or ALL) to which command applies (defaults to 1).
XF,YF,ZFLocation of the object to be at the focus point (center of the window) in the global Cartesian coordinate system. If
XF= AUTO, allow automatic location calculation. IfXF= USER, use focus location of last display (useful when last display had auto focus).KTRANSTranslate key:
0
—
Interpret numerical
XF,YF,ZFvalues as described above.1
—
Interpret
XF,YF,ZFvalues as multiples of half-screens to translate from the current position in the screen coordinate system. Example:XFof 2.4 translates the display approximately 2.4 half-screens to the left in the screen X (horizontal) direction.2
—
Interpret
XF,YF,ZFvalues as multiples of half-screens to translate from the current position in the global Cartesian coordinate system. Example:XFof 1.5 translates the display approximately 1.5 half-screens in the global Cartesian X direction of the model.
Command Default
Focus location is automatically calculated to be at the geometric center of the object (modified for centering within the window, depending upon the view).
Notes
Specifies the location on (or off) the model which is to be located at the focus point (center of the window). For section and capped displays, the cutting plane is also assumed to pass through this location (unless the working plane is used via /CPLANE). See also /AUTO and /USER commands.
This command is valid in any processor.