ADAMS
ADAMS, NMODES, KSTRESS, KSHELL
Performs solutions and writes flexible body information to a modal
neutral file (Jobname.MNF) for use in an ADAMS analysis.
NMODESNumber of normal modes to be written to Jobname.MNF file (no default).
KSTRESSSpecifies whether to write stress or strain results:
0
—
Do not write stress or strain results (default).
1
—
Write stress results.
2
—
Write strain results.
3
—
Write both stress and strain results.
KSHELLShell element output location. This option is valid only for shell elements.
0, 1
—
Shell top surface (default).
2
—
Shell middle surface.
3
—
Shell bottom surface.
Notes
ADAMS invokes a predefined Mechanical APDL macro that solves a series of analyses and then writes the modal neutral file, Jobname.MNF. This file can be imported into the ADAMS program in order to perform a rigid body dynamics simulation. For detailed information about how to use the ADAMS command macro to create a modal neutral file, see Rigid Body Dynamics and the Ansys-Adams Interface in the Substructuring Analysis Guide.
Before running the ADAMS command macro, you must specify the units with the /UNITS command. The interface points should be the only selected nodes when the command macro is initiated. (Interface points are nodes where constraints may be applied in ADAMS.) Only selected elements will be considered in the calculations.
By default, stress and strain data is transferred to the ADAMS program for all nodes, as
specified by the KSTRESS value. If you want to transfer
stress/strain data for only a subset of nodes, select the desired subset and create a
node component named STRESS before running the ADAMS command macro.
For example, you may want to select exterior nodes for the purpose of visualization in
the ADAMS program.
The default filename for the modal neutral file is Jobname.MNF. In interactive (GUI) mode, you can specify a filename other than Jobname.MNF. In batch mode, there is no option to change the filename, and the modal neutral file is always written to Jobname.MNF.