Warning: Some Faces Are too Small to Be Meshed
This warning message appears in case Speos has failed to mesh a face. For more information refer to Meshing Warnings.
To try to correct the issue, you can analyze the problematic faces:
- Double-click the warning to select all the faces impacted.
- Locate where the faces and bodies are, using one of these two options:
- Copy/paste in structure tree (Ctrl + C then Ctrl + V)
- Create a group and explode it.
- Analyze the face:
-
In the Measure tab, use the SpaceClaim Measure tool .
An incorrect face should result as a line or area equal to or less than 0.
- Use the Check Geometry SpaceClaim option (only if used the copy/paste option in step
2) to look for self-intersections, topology errors, etc.
-
- Try to modify the impacted faces according to the analysis.
- However, if all three following conditions are met, contact the Ansys support:
- Face area is greater than 0
- There is no error on Check geometry
- The face is different in CATIA (if you performed an external CATPart import)