Sensors
Known Issue |
Workaround or Solution |
---|---|
Two tangent faces, each one having a 3D Irradiance sensor applied, are not supported in simulation. |
Make sure to select geometry (face or body) that is not tangent to another geometry (face or body) on which a 3D Irradiance sensor is already applied. |
Results of Sequence Detection (*.OptHash *.OptSequence) are not removed if you run again the simulation with the sensor Layer parameter set to another value than Sequence. (TFS 674798) | |
In a sensor definition, when applying a XMP template with a certain type (photometric, radiometric, etc.), and defining the same type in the general section, an error occurs. (TFS 450549) | Do not consider the error as it does not prevent the simulation to run and the results to be correct. |