Aiming Area
The following page helps you understand the purpose of the Aiming Area in a Physical Camera.
The Aiming Area is an important notion of the Physical Camera. The Aiming Area is not a parameter to be set but you need to understand its impact in order to correctly define your system and simulations.
Description
The Aiming Area corresponds to the first face of the lens system surrounded by a bounding box. The optimized propagation engine makes sure that rays launched aim to this area. Once rays interfered with the aiming area, the propagation is done following the Monte Carlo algorithm from the Aiming Area.
-
In case of a Direct Simulation the Aiming Area corresponds to the first face of the lens from the source.
-
In case of an inverse simulation the Aiming Area corresponds to the first face of the lens from the sensor.
Direct Simulation VS Inverse Simulation
- To simulate an Ambient Source, use the Inverse Simulation.
- To simulate all other sources, use the Direct Simulation.
When rays generated from the sensor enter the Aiming Area, the propagation is mainly done specularly. That means Speos has no control over the propagation (direction) of the rays afterthat. Therefore, when rays exit the lens system (after last face of the light box used), the convergence will be correct in case of Ambient Sources, but very slow in case of other sources.
Emission Angle of Sources
The sources with an emission angle correspond to the source for which you can define an intensity diagram (Surface, Luminaire, Display).
If a ray launched from the Aiming Area is outside of the emission angle of the source, the ray is lost. If the emission angle is small, the convergence is very slow. We recommend you to convert your source in a Ray File Source as rays are hard-coded.