RMxprt Example Part 4: Analyze the Design

Before analyzing a design project, a few options should be decided using the following procedures:

1. Click Tools > Options > General Options to open the Options window, displaying a hierarchical list of options. Click the + button next to Machines to show the following choice: Wire Setting.

   The System Libraries setting should be set to American.

2. Click OK to close the window.

3. Click RMxprt > Analysis Setup > Add Solution Setup.

   This displays the Solution Setup window. Add the following values.

   Load Type	Const Power
   Rated Output Power	550 W
   Rated Voltage	220 V
   Rated Speed	1500 rpm
   Operating Temperature	75cel

4. Click OK to close the dialog to save the Setup.
   

5. Click RMxprt > Validation Check to ensure that all values have been set.

   If any items do not pass validation, use the diagnostic information in the Message Window to resolve any issues.

6. When the design has been validated, click RMxprt > Analyze All.

The progress of the analysis is shown in the Progress window.

To continue to Part 5 of the example, go to Create Reports and View Output.