Input Half-turn Length

Select or clear this check box to specify whether or not you want to enter the half-turn length. When this check box is selected, the row Half Turn Length appears the next time you open the Properties dialog box. When this check box is cleared, the row End Adjustment appears instead.

Half-turn Length

The half-turn length of the armature winding. It is available when Input Half-turn Length is selected.

End Adjustment

The end length adjustment of the stator coils, which is the distance of one end of the conductor extending vertically beyond the end of the stator. It is available when Input Half-turn Length is cleared.

Base Inner Radius

The inner radius of the base corner.

Tip Inner Diameter

The inner diameter of the coil tip.

End Clearance

The end clearance between two adjacent stator coils.

Coil Wrap

Single-side coil wrap insulation thickness.

Slot Liner

The thickness of the slot liner insulation.

Wedge Thickness

The thickness of the wedge insulation.

Limited Fill Factor

The limited slot fill factor for the wire design.

Layer Insulation

The thickness of the insulation layer.

Bottom Insulation

Bottom insulation thickness.