This section describes the options available for mapping of material properties for *MAT_4A_MICROMEC (*MAT_215). The initial input is the same as above, with minor changes to the target options and additional cards specific to the initialization of material properties for (*MAT_215) with the *INITIAL_STRESS_SOLID card.
| TargetMaterialModel = 215 |
Define the ID of the target material model corresponding to [20]. Here, it must be 215. |
| MapStress = YES | Define whether *INITIAL_STRESS_SHELL cards should be written. If data should be made available for the *MAT_215 material model using *INITIAL_STRESS_SHELL cards, this option must be YES. Newer versions also map the stresses stored on the source mesh to the target mesh. These stresses may be the result of a spring-back simulation, performed within Moldflow. If stresses should not be mapped, exclude them from the source mesh. |
| MapMainDir = NO |
Activate the mapping of the main directions to *ELEMENT_SOLID_ORTHO cards. For usage with *MAT_215, this option is NO. |