The following table describes the scenarios in which a washer might not be generated for a hole:
Table 1: Washer Limitations
| Scenario | Description |
|---|---|
| A hole is shared by two faces | The hole is not detected, and a washer is not generated around the hole. To ensure that a washer is generated, you should merge the faces. |
| A local mesh control is set | Washers are not generated on any face to which a local mesh control has been applied. |
| The Defeature Size is greater than the Minimum Edge Length | Washers might not be generated. |
| A hole has a diameter less than the Minimum Edge Length | A washer will not be generated for the hole. |
| The Min Size and Element Size are set to the same value | Washers might not be generated. |