Including CFD-Post Data in the Project Report

You can set whether or not to include CFD-Post data in the project report.

To include CFD-Post data:

  1. In the Project Schematic, right-click the Results cell for an Ansys CFD analysis system or Results system and select Properties.

  2. In the Properties pane, select the Publish Report check box.

  3. Repeat the previous two steps for each Results cell to be included in the project report.

Note:

  • Only 2D content such as graphs and figures are supported in the project report. If interactive 3D content exists, it is displayed in 2D format.

  • The format/style of CFD-Post reports produced from Workbench are consistent with general Workbench-produced reports; reports from standalone CFD-Post use the standard CFD-Post format.