Change Solution Control Settings

Change the solution controls for the co-simulation.

  1. In the Outline, click Solution Control.

    Corresponding settings are shown below in the Properties pane.

  2. Set Duration Option to End Time.

  3. Set End Time to 20000 [s].

    This is how long it will take the core to approach its steady-state temperature with the 150 AMP inductive heating excitation from Maxwell.

  4. Set Time Step Size to 1000 [s].

    This is the time step size to be applied to the thermal analysis (not to Maxwell's Eddy-Current analysis, which is run independently of any times set in System Coupling).

Note:  These settings will override transient settings defined in the participant products.