KLIST

KLIST, NP1, NP2, NINC, Lab
Lists the defined keypoints or hard points.

Valid Products: Pro | Premium | Enterprise | PrepPost | Solver | AS add-on

NP1, NP2, NINC

List keypoints from NP1 to NP2 (defaults to NP1) in steps of NINC (defaults to 1). If NP1 = ALL (default), NP2 and NINC are ignored and all selected keypoints (KSEL) are listed. If NP1 = P, graphical picking is enabled and all remaining command fields are ignored (valid only in the GUI). A component name may also be substituted for NP1 (NP2 and NINC are ignored).

Lab

Coordinate listing key:

(blank)  

 — 

List all keypoint information.

COORD  

 — 

Suppress all but the keypoint coordinates (shown to a higher degree of accuracy than when displayed with all information).

HPT  

 — 

List only hard point information.

Notes

Lists keypoints in the active display coordinate system (DSYS). An attribute (TYPE, MAT, REAL, or ESYS) listed as a zero is unassigned; one listed as a positive value indicates that the attribute was assigned with the KATT command (and will not be reset to zero if the mesh is cleared); one listed as a negative value indicates that the attribute was assigned using the attribute pointer (TYPE, MAT, REAL, or ESYS) that was active during meshing (and will be reset to zero if the mesh is cleared).

This command is valid in any processor.

Menu Paths

Utility Menu>List>Keypoints>Coordinates +Attributes
Utility Menu>List>Keypoints>Coordinates only
Utility Menu>List>Keypoints>Hard Points