For a chosen combination of simulation type (Assumed Strain, Scan Pattern, or Thermal Strain) and stress mode (Linear Elastic or J2 Plasticity), run simulations of the calibration part in Additive Print.
Below are some important considerations when you set up the calibration simulations for all simulation type and stress mode combinations. Keep these settings consistent for all calibration simulation iterations.
Note: The remaining content of this chapter is accessible for licensed users with Ansys credentials. If you already have an Ansys account, log in by clicking CUSTOMER LOGIN in the upper right corner of the help page. If not, contact your local Ansys support provider to learn about license options.