Creo Parametric (Pro/ENGINEER Wildfire)
The following properties can be exported to Creo Parametric or Pro/ENGINEER Wildfire, depending on which data table you are exporting from.
Note: Only compatible with Creo Parametric or Pro/ENGINEER Wildfire
5.0.
MaterialUniverse
- Compressive strength
- Density
- Poisson's ratio
- Specific heat capacity
- Tensile strength
- Thermal conductivity
- Thermal expansion coefficient
- Yield strength (elastic limit)
- Young's modulus
ASME BPVC
- Density
- Min. tensile strength
- Min. yield strength
- Moduli of elasticity
- Poisson's ratio
- Tensile strength
- Thermal conductivity
- Thermal expansion
- Yield strength
ESDU MMDH
- 0.2% proof stress, compression (L)
- 0.2% proof stress, tension (L)
- Coefficient of thermal expansion vs. Temperature
- Density
- Poisson's Ratio (L)
- Specific heat capacity vs. Temperature
- Thermal conductivity vs. Temperature
- Ultimate tensile strength (L)
- Young's modulus, tension (L)
Global Polymers Plastics
- CLTE, Flow
- CLTE, Flow (TMA)
- CLTE, Transverse
- Coeff of Thermal Expansion vs. Temperature
- Compressive Strength
- Density
- Poisson's Ratio
- Specific Heat Capacity
- Specific Heat Capacity vs. Temperature
- Tensile Modulus
- Tensile Modulus vs. Temperature
- Tensile Modulus vs. Temperature, Dynamic
- Tensile Strength
- Tensile Strength (Elastomers)
- Tensile Strength at Break
- Tensile Strength at Yield
- Tensile Strength at Yield (Elastomers)
- Tensile Strength at Yield MD (Films)
- Thermal Conductivity
MMPDS-2024
- Comp Yield Strength, L
- Density
- Modulus, L
- Poisson's Ratio, L
- Specific Heat
- Thermal Conductivity
- Thermal Expansion
- Ultimate Tensile Strength, L
- Yield Strength, L