Signals Tab (Edit Component)

The Signals tab lists the names and values of signals for digital elements. Parameter information can display for Values, Optimization, Tuning, Sensitivity, and Statistics. you can also add, edit, or remove properties.

Value

• Name – Displays the names of component parameters. Names can be edited for case only.
• Value – Change the initial values of parameters.
• Unit – Set the unit of measure for the parameter value.
• Netlist Unit – Set the unit of measure used when the parameter is netlisted.
• Description – Enter a description for the parameter.
• Callback – Associate a callback script with the parameter.
• Signal Type – Shows the type of signal (for example, real or bit) set for the parameter.
• Direction – Select the parameter direction (In, Out, InOut, or Don’t Care).
• Show Pin – Controls whether the parameter pin is shown on a schematic.
• Default SDB – Enable the value to be stored in the project SDB.