Viewing Winding Results (Eddy Current)

To view winding results for Eddy current solutions:

1. In the Project Manager tree, right-click the Results folder, and then click Solution Data on the shortcut menu.

The Solutions window appears.

2. The Design Variation box shows the current design. Optionally, click the [...] button, and choose a design variation solved during an optimization or parametric analysis from the Set Design Variation dialog box.

3. In the Simulation drop-down menus:

• Select the solution setup from the left drop-down menu.
• Select the solved pass data you wish to view from the right drop-down menu – either the LastAdaptive pass, or an intermediate AdaptivePass. If LastAdaptive is selected, the Freq drop-down menu is enabled for you to choose frequency. If AdaptivePass is selected, the Pass drop-down menu is enabled for you to choose the desired intermediate pass.

4. If the design includes windings, the Winding tab displays the following columns: Flux Linkage[Wb], Induced Voltage[V], Input Current[A], Input Voltage[V], and Current[A]. Results listed in these columns are complex quantities. The Format tab allows you to customize how values are displayed by setting the desired width, precision, and whether to use scientific notation.

• For Current type windings: Flux Linkage, Induced Voltage, and Input Current results are shown. The other quantities are shown as N/A (not applicable).
• For Voltage type windings: Flux Linkage, Induced Voltage, Input Current, and Current results are shown. The other quantities are shown as N/A (not applicable).
• For External type windings: Flux Linkage, Induced Voltage, and Current results are shown. The other quantities are shown as N/A (not applicable).

5. Click Close to close the Solutions window.