Validating RMxprt Projects

Before you run an analysis on a model, it is very important that you first perform a validation check on the project. When you perform a validation check on a project, RMxprt runs a check on all setup details of the active project to verify that the necessary steps have been completed and their parameters are reasonable.

To perform a validation check on the active project:

1. Click RMxprt > Validation Check. You can also click the Validate button on the Simulation ribbon.

RMxprt checks the project setup, and then the Validation Check window appears.

2. View the results of the validation check in the Validation Check window.

The following icons can appear next to an item:




	Indicates the step is complete.
	Indicates the step is incomplete.
	Indicates the step may require your attention.



3. View any messages in the Message Manager window.
4. If the validation check indicates that a step in your project is incomplete or incorrect, carefully review the setup details for that particular step and revise them as necessary.
5. Click RMxprt > Validation Check to run a validation check after you have revised any setup details for an incomplete or incorrect project step.
6. Click Close.